Ben days friends, I have a Frigidaire brunette washer, the flaw that presents is that when it reaches the squeeze cycle, it drops the water and begins to wash again, it does not stop, once it drops the water instead of spinning (centrifuging) , start to wash (Chaca, chaca, chaca) without water, then fill and rinse normally and when it touches the final squeeze it drops the water, and begins to wash again (chaca, chaca, chaca) instead of turning (centrifuging), hopefully can you help me, and thanks beforehand...

Regards Alfredo Veracierta. Under the transmission case there is a roller (bearing or bearing or ruleman) that you will have to replace because it is no longer fulfilling its function. It must turn clockwise so that the spin drum can perform its work. Review and comment on it. The front part of the washing machine cabinet can be removed to look inside. To do this you would have to unhook the two metal locks between the upper body and the front of the cabinet with the help of a blade screwdriver. The locks are approximately 10 cm from each front corner. Once both locks are released by pushing them exerting some pressure on them, you can lift the upper body to approximately 45 degrees approx. You are looking to keep it in place and proceed to remove the two screws from the top of the front sheet of the washing machine cabinet and pull towards you about 10 to 15 cm maximum and then unhook it from the bottom and finally pull up. Programs the washing machine at the spin stage without water and without clothes and see what happens at the roller level. Will the structure that covers it have been cleared or broken? In the washing stage as well as in the rinsing stage, the main motor rotor will turn in one direction (counterclockwise) and when it corresponds to it it will spin in the opposite direction. You can remove the belt between both pulleys and observe the behavior of the main motor pulley in the spin stage and then program the washing stage only with water at its lowest level and observe the direction of rotation of the main motor pulley. Thanks and regards.