Good morning everyone, I have this Whirlpool AWG371 washing machine and the bearings broke, buy the replacement kit that comes with the new axle and bracket and the three stainless steel screws that supplant the rivets, but I can't take any way out the broken rollers, it is more just the housings of the rollers left on the lid, but I have tried hitting, heating, and several other things but they do not move, someone will have an idea of how to remove them or if they are put in a different way than Pressure? , I know, if someone throws a grateful idea at me

Hi It has to leave the opposite of how it entered, the problem is that it is stuck with rust and tartar and only comes out with patience. Apply brake fluid, heat and when it is very hot, you put it in cold water, so with that sudden temperature change, you get it off, many times you have to do this several times regards

You have to clean the edges of the rollers well so that the w40 or other liquid is lowered and give the center of the ruler a hard blow. With some short iron or something that fits there. And patience is going to come out

Dear, for me the best option when the cuvettes are left by the vat lid is to give it some welding points in order to create some "bulge" points and then support the tapping tool to extract the cuvettes at these points. regards