⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta. 🔥 Aprovechar oferta ahora 🔥
Clothes Washers and Dryers

Washer does not spin

Naza pereyra
hace 5 años
hace 5 años
Hello I have a luxury link ewt07a and the washing was very slow and not centrifugal change capacitor and walk the wash better but you want to centrifuge it does as the first steps to start but so it stays hopefully they can help me greeting and thanks ..
Fox896
Fox896
372
hace 5 años

Ideally, you should verify the farads of the capacitor usually happen that fail even being new

Responder
luis38
luis38
95.432
hace 5 años
hace 5 años
Dear, remember that the brake actuator works in parallel with the pump. Therefore it is at rest during washing. When the actuator does not work, it only rotates the agitator during centrifugation. regards
juan guillermo caceres
hace 5 años
hace 5 años
Hello, remove the belt and check if the spinning motor spins at speed, to eradicate any doubt or corroborate you can carefully support a piece of wood in the motor pulley and press, if the motor cannot counteract that braking force and it stops at one, then its motor is with coil problems. regards
Naza pereyra
hace 5 años

I was just able to ride a revice and everything is going but 220 volt does not reach the engine that makes the water drum the vane turns but the engine that makes the drum to fit the motor so that it swears it does not reach 220 vq it can be many thanks

Responder
Virussva
hace 5 años
hace 5 años
Hi, it can be: Dirty filter Drain hose is not at the indicated height Water pump faulty Among other things... I hope it helps you. * I think that if I remember correctly in the manual it says that the drain hose must have a minimum height.
Naza pereyra
hace 5 años

The hose does not think it has no censors goes what I see and the drain pump is new and it goes x what I see filter does not have I think is where to disassemble the soap dispenser can be or the platelet is eliminating causes

Responder
Reparaciones similares solucionadas

¿Conoces una solución?

¡Aprende a reparar con estos cursos YoReparo!

4.25
(8)

Reparación de Placa Main TV LED con el Ing. Picerno

Ing. Alberto H. Picerno
$ 40 USD
$ 20 USD
4.87
(15)

Curso Diseño de Amplificadores de Máxima Fidelidad

Maximiliano Resch
$ 29 USD
$ 13 USD
4.64
(45)

Curso Tecnología Inverter - Fabricación de probadores y herramientas

Yamil Alarcón
$ 240 USD
$ 40 USD
¿Tienes una mejor respuesta a este tema? ¿Quieres hacerle una pregunta a nuestra comunidad y sus expertos?
Regístrate gratis