⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta.
🔥 Aprovechar oferta ahora 🔥
Clothes Washers and Dryers
How to join suncho rubber bellows drean 189
422
hace 5 años
hace 5 años
COLEGAS, I AM RENYING ENOUGH TO BE ABLE TO FIT THE WIRE SUNCHO THAT ADJUSTS THE FUELLE OF THE INTERNAL PART OF THIS WASHER, IS THERE ANY WAY TO MAKE IT FAST AND WITHOUT DOING SO MANY ADVANTAGES? I TRY TO JOIN IT WITH A CLAMP WITH CURVED POINTS FOR SEEGER WASHERS BUT THERE IS NO WAY WHEN I GET TO CLOSE THE POINT WITH THE WIRE CIRCLE IT IS SAFE, SINCE MANY THANKS
235
hace 5 años
first of all make sure that the wire fits in the groove of the bellows if the afura wire is mounted somewhere you will not be able to fit it, then I from the front and x the part of the door attached to the side of the hook with one hand and with a screwdriver (in my case tork) that I put in the roller shot stretching the spring also from the front to achieve the hitch, always from the front and x the door, since in an occasion doing the same from above and with a clamp that slipped away I had to put 2 points on the eyebrow hehe
95.432
hace 5 años
hace 5 años
Dear, here is another option. Looking at the washing machine, the spring is on the right side.
Remove the rod that goes from the cam to the soap dish, to have more space.
After placing the clamp in place, hold the side of the hook with the left hand and with a round-nose pliers used in handicrafts, insert it into the spring curl and pull on the side of the hook until you can mount both parts regards
151
hace 5 años
hace 5 años
Good morning Lucas ... I with a soft wire I take the tips of the spring leaving the tips free to be able to hook .. And. With the wire ago a tourniquet until the tips come together .. And soon ... Greetings and Successes .. .
25.004
hace 5 años
hace 5 años
Washing machine tilted slightly back.
Wire hook, and flat screwdriver with notch in the tip.
The connection is made to the side, near the programmer, to be able to pull with the hook more comfortably.
The wire hook is inserted into the second ring, and hooks into the first. With the screwdriver, the ring is tightened, on the part of its hook, while the other end is pulled with the wire hook it had built.
23.662
hace 5 años
hace 5 años
Partner, I do what ROBERE says, a thick wire (San Martin type) more than 50 cm. on one end a hook, on the other end a roller to pass a phillips screwdriver. the spring of the ring of the soap dish, hooked in the second loop of the ring, while at the other end of the ring I take it with a pincer, it is held on that side while it is stretched by the wire from the crossing of the screwdriver to the hitch, I assure you that it is not difficult and in less than 10mtos the work is finished. Greetings to colleagues
Reparaciones similares solucionadas
¡Aprende a reparar con estos cursos YoReparo!
Curso Refrigeración Comercial Aplicado a Diagnóstico y Reparación
Ing. Georga Melgarejo
$ 40 USD
$ 13 USD
¿Tienes una mejor respuesta a este tema? ¿Quieres hacerle una pregunta a nuestra comunidad y sus expertos?
Regístrate gratis
Ad