Hello friends and good day, I tell you, this time I have a problem with the washing machine mentioned in the title and it happens that it does its functions correctly but when it reaches the point that it must centrifuge the water it does not do it correctly, because if it expels the water with the pump but only the agitator rotates, and thoroughly checking I have noticed that the thermostat is connected together with the drain pump, which seems illogical since the thermostat is activated and makes the basket disconnect, therefore only the agitator moves, does anyone know if it is normal for it to be connected to the pump?, according to my logic it tells me that it must be deactivated during centrifugation to be able to couple the basket and drag it, it should be mentioned that the transmission change was made because the original was broken, but an exact one was installed, (the problem I had before), I'm stuck there because I don't know what else to do.
This is the washer panel
This is the wiring of the lower part
This is the thermal actuator connection
This is the thermo actuator in question , I put something between the lever and the plunger to simulate and fool the board
Update
Here you can see the position of the actuator lever, in red, I have placed a paper mattress to lift the clutch and do the washing, in yellow, I tried to turn the piece around but it has position and does not fit when I give it the turn, the yellow arrow, shows the free clutch, therefore when the pump is turned on, the thermo actuator is activated leaving that "lever" in that same position and would not allow the basket to be squeezed correctly.
Hello friends, I commented that the fermin007 solution was indeed correct, the original piece was searched, the change was made and problem solved, the team is washing normal and working very well, thanks for your answers 
I think I answer the question
