Good morning people, I will tell you in more detail the fault, if I start any washing program this takes a few seconds (approximately 30) and begins to load water, then wash and at the time of draining to start the rinse, stop and It shows error E3. If instead of washing, I program to centrifuge, the first minutes where it is supposed to start the drainage, it does not, then it begins to spin and in the pauses where it should drain and centrifuge it does but without draining reaching the end of the spin without problem . I checked the wiring of the drain pump feed and it's fine. I also checked the voltage that should leave the board and there is no voltage. Les upload some photos. 20191101_185555 [1] .jpg [4.92MB] 20191106_122243 [1] .jpg [4.17MB] 20191107_093837 [1] .jpg [4.25MB] I forgot to tell you that I discarded the drain pump because I had a new one.