Good, I have the following problem with a DREAN EXCELLENT 1390 brand washing machine. The problem is that it doesn't load water. This led me to change the solenoid valve because when tested with a direct current of 220 it did not open and therefore the water did not pass. Change the component, but the problem persists. What I notice after an observation in detail is that when I set the timer of the programmer at the beginning of the wash, the knob of this timer begins to turn, turning a full turn, then brakes but does not perform neither the load nor any function. I turn the washing machine off again and when I turn it on again, turn the knob again, as if something was loose or broken inside the programmer. On some occasions it turns 1/2 round, but on others it turns full turn or more turns, without stopping or if it stops it does not perform any function. I will appreciate the tests that I must perform or test before disassembling and replacing the component. Attached image of the washing machine. [Img] https://cdn2.yoreparo.com/uploads/imagen_post/0003/66/ae651d937ceeb20ea44eb84c29833d4bb73076de.jpeg [/img] Regards

Nico: your observation is very reasonable, and I comment on the fault you describe apparently swept the gears of the timer I suggest you change it taking care to take note of where each cable connects (if you can leave a bit of timer cable in each connection to that you do not lose the tips and write down) Take the piece in physical form so that you buy it, with the make and model of the device lucky with your failure and comment

Hello, the problem may be the triac that feeds the timer motor, if you have knowledge in the matter, try disconnecting some of the wires of the timer motor, leave it isolated, then program a wash a check if it starts working the door, then the load of water, once loaded it advances the timer manually and controls if it starts to rotate the drum, continues advancing manually until it reaches the end of the wash and controls if it fulfills the other functions, emptying, rinsing, and centrifuging, if it does everything well it is necessary to locate The damaged triac and replace it, regards.

Hello, greetings to the forum. This model of washing machine has an electronic plate inserted in the programmer. Generally when it starts to turn, it indicates some fault in the peripherals. The engine controls the coals, resistance, ntc sensors. Door lock. Etc. Comment resultsr Greetings