lusangor

56.366

hace 6 años

http://docplayer.es/19001709-Manual-de-servicio-lavarropas-automatico-carga-superior-philips-whirlpool-awg-050-indice-caracteristicas-tecnicas-pag-1-11.html

ayala enrique

87

hace 6 años

okamigo it may be that if the blok does not go to the door it does not perform any function except energize the pump drain only

lusangor

56.366

hace 6 años

It can be bridged and leave doubts, in the link above, in the previous comment, you also have the service manual

ayala enrique

87

hace 6 años

Dear, I managed to do it walking I had two wires the programmer loose now walks but does not load water I have the contact G36 loose I do not know in which terminal of the programmer goes around there I have 55 and 68 if you can guide me
55 two rows and I don't have anything connected there, so I want to go there

lusangor

56.366

hace 6 años

Check where it comes from, what it belongs to and look at the service manual, on page 13 and 14. You can also help yourself with a flashlight and look at the terminals of the programmer, where you suspect it is going, if it is marked with the hole left by the connector male

ayala enrique

87

hace 6 años

Now I found it where does the G36 terminal is the terminal where the motor is connected programmer this comment is if you serve some forista

lusangor

56.366

hace 6 años

does it work for you ??

ayala enrique

87

hace 6 años

The electric current to the programmer is almost working now, I am going to check the continuity of the power cables, because I connect 220 directly and it works normally but I take the direct cable and after a while the programmer motor stops working