IMG_20180626_175440.jpg [312.93kb] 1530035368847849527014.jpg [3.23MB] Good afternoon I tell you that it goes into error for water overload check the pressure switch hose and it's ok change the pressure switch and stay the same when I blow the pressure switch it feels that it works but does not cut the entrance, if I give more pressure it goes in emergency due to overload I don't know what else to do since I have to change the plate I also measured the electro valve already tension, it is not that the water enters because it locks I took out the plate and I saw that there was a record that your contacts are burned I mark them in the photo that sector

Hello, do not comment if the voltage reaches the solenoid valve since you connect it, if so, the problem is the triac that feeds the solenoid valve on a plate that is damaged Regards

Hello, check continuity in the wiring of the pressure switch to board, regards.