Drean Excellent Blue 6.08 cuts the light
Well obviously there is some short. That's why the thermal jumps.
Let's review you say that it loads water with this we discard blocapuerta and solenoid valves.
You unplug the resistor therefore it is not.
I test the engine directly and it doesn't cut the light.
Only the pump is left with some cable, the plate. Without turning on the washing machine, does the light jump?
For me that is the plate since the error I was throwing was the 6 blinks and the engine I tested it outside, also on the plate you see blackened tracks and I have already changed plates before they presented the same.
Tomorrow I am going to test the direct pump and measure the coil to see what happens if it is ok, would that be just a matter of plaque?
Data I told you to put the new machine and I started to spin out the water and when it started to turn the engine cut the light.
I unplugged the engine and started to wash and blow through the hose and cut off the solenoid valve and the light did not turn off.
Schedule the centrifugation and the pump went 5 minutes and the light did not turn off ... everything suggests that the engine is the problem but what does not close me is that I tried it at home and did not cut the light because it can be? How should I test the engine to be sure it is the problem? Thank you!
Hi lucaas that happens because the engine is derived to ground. If you leave it that way while nobody touches the engine when it is running, nothing will happen.
Reparaciones similares solucionadas
¡Aprende a reparar con estos cursos YoReparo!
