⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta. 🔥 Aprovechar oferta ahora 🔥

Clothes Washers and Dryers

Lav. Drean concept 5.05 v1.se broke the wash shaft

Gereño

hace 6 años

Good afternoon. I have a washing machine Drean concept 5.05 V1. Be broke the plastic striated tip what goes on the plate or stirrer. It is the tip of the wash shaft. The washing machine has a year. is in good condition. For me it came with factory failure. The question is : Can I change, just the wash shaft without changing the spin axis? Whatever the answer can tell me the steps to follow. Thank you very much already

Comentar

lusangor

56.366

hace 6 años

Hello, here I send you a link from a forum post, where you have a tutorial. regards http://yoreparo.com/electrodomesticos/lavadoras/drean/preguntas/1373715/como-change-wheel-waste-automatic-drean-concept-5-04

Comentar

luis38

95.432

hace 6 años

Estimated, it is possible to change only the wash shaft, without having to change the spin axis or disassemble the whole machine. regards

Comentar

Gereño

hace 6 años

Good afternoon .
Thank you very much to all for your answers.
I would like to know what are the steps to change only the wash shaft and its retainer?
I want to know if I have to remove the cube or Just take out the coupling and hit the bottom shaft towards the top so that the shaft comes out with its catch and the lock?
Or is it that I must follow all the steps as if I would change everything complete?



Responder



juan guillermo caceres

23.662

hace 6 años



hace 6 años

Hi, really these striated tips are a crap like quality, and I attended more than a dozen teams with that problem, such a vital element for water agitation would at least have to make it more reinforced. At times changing the washing axis can be recovered, this involves a very careful disassembly to avoid subsequent leaks that may be left, the time of use is very limited and one has to change the entire axis in the long run, keep it in mind. regards

Comentar

Gereño

hace 6 años



Responder

juan guillermo caceres

23.662

hace 6 años

Hi, your idea is correct, remove the pulley, replace the nut and hit the wash shaft to the top of the other, there must be an extension of the diameter of the shaft to continue hitting before removing the nut, until its total extraction from inside the drum. regards



Responder