Greetings nastor. Good evening jesus gomez2016. I'm not sure what you're up to. If the cut was due to a power outage for a certain period of time or if there was no water at that time the washer was working. If it was the 2nd case, at least an error code should have been displayed on the panel to tell the user what action to take into consideration. Let us suppose for a moment that in the rinsing stage the electrovalve that participates in the filling (that of the cold water because the hot water is not activated in that stage according to the factory design) of the tub does not respond. In that case it would be necessary to check if its coil has been damaged, or is not receiving current signal from the programming card, or the metal mesh that acts as a filter at the entrance of the electrovula is blocked with solid particles that would have to be removed with a toothbrush and water. Did you observe if there is water in the wash stage and perform that stage without setbacks as well as the stage of the intermediate centrifugation? Comment on this. Thanks and regards.