notice if at the bottom (turn it around) it has a button that if being supported on the floor is not pressed (activated, as if you were ringing the bell of a house without releasing the button --- I put it like this so that you understand since you don't know anything about electronics --- it WILL NOT WORK) that button is safe in case the stove falls unintentionally, the candles are deactivated and there is no risk of burning your house ... plug the stove into the outlet and press yourself that button (keep it pressed) and see if they already light the candles ..... COMMENT LUCK !!!
Hello again!
I took a couple of pictures.
I noticed and I do not see the security button ..
By the way, in the box it says electric heater, I don't know if it's the same as stove. Look on the internet and some call it a stove too, but I really don't know if it's okay to say so haha.
https://i.ibb.co/m5rctM2/IMG-20190529-WA0019-1.jpg
https://i.ibb.co/p4N61Pc/IMG-20190529-WA0025.jpg
https://i.ibb.co/v1FQXXp/IMG-20190529-WA0024.jpg
https://i.ibb.co/5B9RCC8/IMG-20190529-WA0021.jpg
https://i.ibb.co/przGT1f/IMG-20190529-WA0023.jpg
I add: Test if you had power to plug it in and yes, it has. Touch the rack, and also.
I really don't know why this happens.
Oh sorry.
It only has two lights ... one on each power button that they turned on when they were active. Now it does not turn on any.
With grid I was referring to metal sticks that heat up and give heat. Try a pager and it has current.
click on one end you have to be sure (if that is just the phase wire) if it is neutral it will not mark anything (ideally a tester) but try putting on one end and on the other you have to mark on both ends of the fuse (this indicates that the fuse is sound (otherwise the fuse is blown)
Elektron, probe and on one side has current, on top of the fuse too, but not on the other end.
Where there is no current, it is from the far right, horning us with the photo you sent me (that is, on the side of the cables)
Will it be burned?
I didn't do the use of a piece of cable yet
Ah well! I saw the picture, more than clear now.
I will try and comment.
Thanks for all the help and work of editing the Elektron photos!
ELEKTRON WORKED !!
Thank you very much friend!! :)
Turn it off just as you said so you don't have problems.
Now I take out the fuse and buy the same one as soon as I can.
The last thing would be ... The fuse I cut it by cutting its wires and then with the new one already in hand I hooked the wires and must I solder?
Or will it just come out by pulling a little and the new one "plug" the wires into the holes?
Barbaro! Thank you very much for all the help and patience friend, You really passed!
Big hug!
Hello!
As soon as I get home from work, I take it apart again and upload photos.
No problem, I thank you for explaining it that way since I am quite ignorant on the subject. If I remember correctly I don't have that button, but I will check again
Thank you very much for the help!
It's this ... except for the last button that mine doesn't bring
http://ventas-casadelaudook.mercadoshops.com.ar/convector-calefactor-electrico-axel-2000w-con-termostato-89xJM