⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta. 🔥 Aprovechar oferta ahora 🔥
Microwave oven

Durabrand model 17px60-20 does not heat

Ramon Alcides Gilez
hace 6 años
hace 6 años
Good afternoon, I'm checking this microwave of a neighbor turns on everything well but does not heat. I am a technician on TV and I was watching in the forum and I followed some tips, I checked with the multimeter the fuse that usually opens, and it had continuity, then I measured on the legs of the magnetron and it also gives me continuity and finally change the power diode but still unheated Where is the problem. Thank you.
Fermin 007
Fermin 007
57.307
hace 6 años
hace 6 años
In the magnetron, even if it marks you well, the internal filament is usually damaged and it is not detected, change the magnetron, if you have a used one out there, try it, if it already works and heats up, change the new magnetron or if the used client wants it , you can put it a little cheaper, greetings
Ramon Alcides Gilez
hace 6 años

Thank you Fermin for your help but I don't have microwaves because I don't repair them, but if you have any idea how much the magnetron can leave, I will tell him if he wants to repair it. Thank you.

Responder
Fermin 007
Fermin 007
57.307
hace 6 años

Everything depends on whether you are a country, well if you are from Mexico an approximate, the magnetron goes between 350 Mexican pesos to 350 or so, of course more labor, I have put almost used of the microwaves that are thrown in the scrap yards , you will see that they sell them to me at 10 or 15 pesos and very good still hehe you have to contribute to the environment, using pieces in good condition, greetings and luck.

Responder
tecnico54
tecnico54
22.006
hace 6 años
hace 6 años
What you have to do before changing the magnetron is to measure if the voltage of the transformer primary reaches voltage. You have to remove the wires from the primary, then you place your tester in alternating current, you place a tip of the tester in a cable and the other tip in another cable to work. For a while the icroondas and see if you have any value, the tetser should mark the tension in your country

¿Conoces una solución?

¡Aprende a reparar con estos cursos YoReparo!

4.87
(15)

Curso Diseño de Amplificadores de Máxima Fidelidad

Maximiliano Resch
$ 29 USD
$ 13 USD
4.64
(11)

Curso Electrónica para Reparación de Placas

Santiago Cediel
$ 29 USD
$ 11 USD
4.64
(45)

Curso Tecnología Inverter - Fabricación de probadores y herramientas

Yamil Alarcón
$ 240 USD
$ 40 USD
¿Tienes una mejor respuesta a este tema? ¿Quieres hacerle una pregunta a nuestra comunidad y sus expertos?
Regístrate gratis