hace 5 años
Hello, in the pins where the relay coil goes you will have to measure the voltage with a multimeter at both ends, only in one will it give you a voltage, if the voltage is between 12 and 13 volts then you will have to place 12 V and if it goes around 24 or 25 Volt will be one of 24 v, there are 5, 12 and 24v.
You could upload a photo of the charred part as well as the relay.
regards
¿Realmente quieres cerrar esta reparación?
Sí
No
¿Realmente quieres reabrir esta reparación?
Sí
No
¿Realmente quieres borrar este post?
Sí
No