Hi, I have a split heater that was given to me but the fan (turbine) did not work, I changed the capacitor (starter) and it works best, but now the problem is that I turn on the two powers, let's say and heat up but very little and I don't know what the Concern ... I don't know what the resistors are called and if they burn or that .. are radiator type

Help me please ... the cold came ...

Hello what brand and model is if you could upload unarmed photos where the cables and switches are seen even better greetings.

It is electrolux ... attached image of the circuit ... it seems to be all ok but for something heats very little

Hi, do you have a white connector with five wires where you connect it? Another thing to check is the diodes under the traffic, there is a diode that seems to be a soldier's leg is outside the plate, check if it is well welded but you have to desolder with a multitester check the greetings diodes.

Hello, the connector goes to the display plate .... and the diode is well welded to the four but one is crooked

hello you have a tester to take measurements to the components if you can not do much more since you have to check several greetings.

How about ... not at the moment I do not have ... but it seems to me that I already found the defect ... when changing the turbine starter they sold me another that supposedly was the same is not the original factory ... well I completely disconnect the engine so that it only starts the resistance and heats up ... but it seems that the turbine turns very fast then it does not let the resistance warm up enough ... can that be? Thank you

Oh and when I turn off the device the turbine keeps turning for a while and turns off later

Hello, how did you decide to compare the capacitor that was sold to you with the factory trailer or did not have it? if it turns very fast it takes longer to stop turning when you turn it off that would be normal but speed is not normal greetings.

I can not compare because when replacing it and see that it was the original, I threw it away ... but it keeps turning hard ... I mean not only because of the shipping ... the capacitor is a CL21 400v I will have to find out the original

Well, I will ... thank you very much for your time ...