ELEkTRÓN

2.042

hace 5 años

if you have the electric blanket model it would be great so you can help ... hug!

Juanuriguen

2

hace 5 años

Ok, the AH3150, 3164 and 1150 models are the same, then the CAH1400, 0800 and the MAH2000 models

ELEkTRÓN

2.042

hace 5 años

What problem has the command? comment so we can give you a hand ... you do not need the command diagram is not complex said command ... comment problem and we tell you how to fix it ... or at least you have to verify to repair it !!! comment !!!

ELEkTRÓN

2.042

hace 5 años

the command only brings an inverter key and a diode ... maybe if it works it may be the thermal fuse of the blanket ... or the diode of the command .... comment on the problem and we will advise you ...

Juanuriguen

2

hace 5 años

Ok, I have 9 controls 7 the same and 2 different, in the 7 I mark the flashing E, the other 2 have not yet reviewed, but I know they do nothing

ELEkTRÓN

2.042

hace 5 años

but do you have the electric blanket to try it later?

ELEkTRÓN

2.042

hace 5 años

Do the 7 controls make you the same? that you bought them in that state already? It would look like a lot that you bought with that factory failure to repair, is that so?

Juanuriguen

2

hace 5 años

Yes, a person buys in batches and they are very good and some to repair, I have been checking voltages and components with one that was fine and I did not care, the only thing was the screen that marks the flashing E

ELEkTRÓN

2.042

hace 5 años

if everything is OK as the controls that are walking is more than probable that if it brings EEPROM memory it is deleted or corrupted and you have to rewrite it in the 7 controls ...

Juanuriguen

2

hace 5 años

And how could I do it, because I've never done it

ELEkTRÓN

2.042

hace 5 años

since the fault is not physical but software in this case!

Juanuriguen

2

hace 5 años

and the output voltages all have them well

ELEkTRÓN

2.042

hace 5 años

you don't have to download the EEPROM firmware and then rewrite it (you need the arduino device to do that) or take it to an electronic replacement house and I think they sell the EEPROM ready to place with the firmware loaded ... and in the best of the cases they rewrote it .... YOU DO NOT LEFT ANOTHER!

ELEkTRÓN

2.042

hace 5 años

THAT IS WHY IT IS ALL OK because the problem is not a physical component but a SOFTWARE

Juanuriguen

2

hace 5 años

Already, I thank you very much for the help, I hope to continue commenting with you more things about problems that arise, again, thanks

ELEkTRÓN

2.042

hace 5 años

give it no problem you can follow me so you have already saved me and any questions let me know ... big hug! and give solution so it serves other users big hug!

Juanuriguen

2

hace 5 años

Ok so I will, a big hug

Juanuriguen

2

hace 5 años

Good morning Electron, is there any chance to ask something directly to you?