Good night. I have this TV which turns the standby LED on and off several times and does not turn on. The voltage of + b is 140 but the tsh does not occur. I measured it and it's fine. Change the driver driver and nothing. Labfuente connect it to a lamp in + b and when the voltages turn on they rise and fall together with the LED and the relay that opens and closes until after a few seconds all the voltages stabilize but the horizontal transistor still does not oscillate. The rest of the voltages of the source are according to the 15 audio diagram that are good and 10.5 where I have 8v. What calls me attention and is making me noise is the rise and fall of tensions at the beginning. Can someone help me to know what voltage should feed the jungle and in which pin? Any help is important. Thank you very much. [Img] 9 [/img]

I have the same TV. With the same problem, it has the two 220x160 electrolytes in good condition, but I can't find the other one they say is smaller, I would appreciate if you can specify, greetings!