Francisco Rodriguez

9

hace 5 años

Thanks for answering. In the touch receiver go. I have 3.3 volt. I don't know if it's insufficient. I disconnect this connector (from the receiver go button) and I still have 3.3 volt. The source delivers to the main 5vol by the pin indicated as A5v. In the rest of pin 0 volt.

Francisco Rodriguez

9

hace 5 años

It is normal to disconnect the main source. Will the source be operated without any order from Stby?

TobíasTv

13.721

hace 5 años

hello, 3.3V on the receiver of the remote is fine, the most modern samsung when you disconnect the main the backlight starts, mass that the main has a power on and bl on ground, when you disconnect it they go to high level, it is great for try

TobíasTv

13.721

hace 5 años

when you disconnect the main, the tensions appear all? the 12 volts?
If your main standby voltage reaches you and since you plug the TV it does not return a moment power on or when you press power, it is dead

Francisco Rodriguez

9

hace 5 años

When I disconnect the main, all the voltages appear, when connecting the main there is only 5 volt voltage at the point indicated as A5v.but it does not take care of buttons or the Stby LED

Francisco Rodriguez

9

hace 5 años

If I disconnect the receiver keypad go. The main board should work?

TobíasTv

13.721

hace 5 años

if the main power on does not come out you will have to replace it
The answer to your last comment is no

Francisco Rodriguez

9

hace 5 años

It is a task. Well, this main is the second. And they assured me that they tested it and it worked. Hence my frustration with the happy breakdown

TobíasTv

13.721

hace 5 años

I am very frankly sorry, particularly when the main one is bad and I cannot repair it, I refer it to the official Service and I get the problem out;)

Francisco Rodriguez

9

hace 5 años

Hello again. I have some doubts. This tv has the tcom attached to the panel. If I disconnect the tcom from the main. The tv should turn on? (stanby backlight etc etc?) Or put another way. If the tcom is disconnected from the main. Should the TV turn on?

TobíasTv

13.721

hace 5 años

Exactly, you're right, without the t-with the TV turn on without image with audio

TobíasTv

13.721

hace 5 años

I throw a center, lei
"The main does not return stby voltage or even turn on the Stby LED"
Do you have tension in the receiver of the remote? what is expected is 3.3 or 5 volts on two of its pins and one mass

Francisco Rodriguez

9

hace 5 años

In the keypad that is tactile. With the receiver go there is voltage of 3 .3 volt on 3 of its pins and ground

TobíasTv

13.721

hace 5 años

that indicates that the micro is powered ... the main is bad ... could it be some fuse smd of the main or that some sub source of the cpu doesn't work ... did you look for a diagram? I'm going to look

Francisco Rodriguez

9

hace 5 años

Since it is the 2nd main I try and the same symptoms as the first. Jay any chance that the tcom has broken the main leaving it without stanby and nothing?

TobíasTv

13.721

hace 5 años

if you disconnect the t-with the arerancaria TV without image obviously, if it is a samsung led start the source and the backlight only by disconnecting the main from the source

Francisco Rodriguez

9

hace 5 años

All that does. This is not led. Take tubes in the backlight