⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta. 🔥 Aprovechar oferta ahora 🔥
TVs

Phone modelo TK2098

Jesusemb2016
hace 6 años
hace 6 años
Good colleagues, you know, could you please send me a photo or tell me the order of where the horizontal-vertical cables that come out of the yoke will go and go to the plate, I do not remember your order, there is a photo of the plate marked with the red color would be where the red would go from the horizontal, and where is the black would be from the horizontal too ?, thank you.
Joansoler
Joansoler
47.894
hace 6 años
hace 6 años
You can clearly see that the pins 1, 2, 3, 5 and 6 of the FBT (Fly Back Transformer) are connected to those 5 posts or pins that you have locked in yellow line . However, those listed pins of the FBT correspond to derivations of its primary winding or coil. This implies that we are faced with the presence of a Chassis of the generic type or universal, adapted to this model of TELEFUNKEN, Those 5 pins are used to adjust the horizontal width of the image, according to the size of the Kinescope or CRT to which it is going to connect this generic chassis. It is the red wire (H +) of the yoke that will be placed on one of these 5 pins, leaving it located in the best width, ie without excess (very wide) or deficit (very small), any fine adjustment is performed from the Service Mode. The location of the black wire (H -) and the vertical section of the yoke (usually yellow and green wires) are in a 4 - pin alignment, similar to the one in yellow, where only three are used and the pin (H +) which has a direct connection to the TSH connector. Regards! Joansoler.
franciscovallarta
hace 6 años
hace 6 años
verifiquelo de acuerdo al diagrama aqui le va. Serie+Dorada++sd20x2,+telefunken+tk2098tk2099,+Samsung+CN5038Z+y+GE+2000.pdf[655.04kb]
Jesusemb2016
hace 6 años

thanks mate please could you please tell me or send me a photo of the way they are used and the order, you know do not study the subject of electronics but repair many tv in the 3 years almost that I take in the subject of electronica I learned and I learn more thanks to you.

Responder
Jesusemb2016
hace 6 años

thanks fellows for your contribution.

Responder

¿Conoces una solución?

¡Aprende a reparar con estos cursos YoReparo!

4.87
(15)

Curso Diseño de Amplificadores de Máxima Fidelidad

Maximiliano Resch
$ 29 USD
$ 13 USD
4.64
(11)

Curso Electrónica para Reparación de Placas

Santiago Cediel
$ 29 USD
$ 11 USD
4.64
(45)

Curso Tecnología Inverter - Fabricación de probadores y herramientas

Yamil Alarcón
$ 240 USD
$ 40 USD
¿Tienes una mejor respuesta a este tema? ¿Quieres hacerle una pregunta a nuestra comunidad y sus expertos?
Regístrate gratis