⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta.
🔥 Aprovechar oferta ahora 🔥
Projectors
Viewsonic PJD 5133 video projector Turn on and off
161
hace 6 años
hace 6 años
Colleagues, good day. I have a viewsonic PJD5133 video projector. The problem is that it turns on normal, gives video, works ok, but after about a minute the device clicks and the lamp and fans turn off, but the blue power LED is on normal. But it doesn't turn on again if I don't disconnect it. Perform maintenance on fans, clean lamp source. What I noticed at first review, is that the lamp's ceramic socket was loose inside the projector. I do not know if it will be a lamp failure or a failure in the lamp source, since it does not throw any overheating code or something like that ... attached photo of the part that was released from the lamp
286
hace 6 años
the bulb is not complete https://electronica.mercadolibre.com.mx/proyectores-y-pantallas/lampara-proyector-osram-p-vip-180%2F0.8-e20.8
161
hace 6 años
as I tell you, that ceramic socket was released from the lamp, the lamp turns on but goes off after a few seconds ... but I don't know if the fault is a lamp or some other problem
161
hace 6 años
because on the other side it has nothing, only the ceramic ... and the lamp only has the exposed connections, it works, but after a few seconds the lamp and fans turn off, but it does not throw any error ...
286
hace 6 años
good logic logical friend ... if you have nothing that ceramic and assume that without ceramic does not harm anything then let's go to the last point why it took off? .... Of course! for failure in the circuit .... maybe you should try another if you do not want to paste that ceramic with kola loka and carbonate then try another one it may be missing or damaged the integrated lamp
161
hace 6 años
I ask you, does the lamp have integrated? because I don't see anything in the lamp, only the electrical connections ... I already tried sticking the ceramic to the lamp, but the fault persists ..
hace 6 años
hace 6 años
Hello good day. Definitely the ceramics that the lamps have, it serves as something, if not, what case would it be to put it on, it may turn on the spotlight, but it may also be what occasions it goes out soon after, although it could also be that the fault is in the ballast, but the only way to confirm it would be by approving it with another lamp. I hope I have been able to help you. Your friend Projector Center www.centraldeproyectores.com
10
hace 6 años
hace 6 años
hello I am with a viewsonic projector with the same problem I repaired it by changing the integrated power top256-yn calculation that must have an equal or similar one is in the source above looking from the back to the right this warmed and turned off I hope it serves you my help
Reparaciones similares solucionadas
¡Aprende a reparar con estos cursos YoReparo!
¿Tienes una mejor respuesta a este tema? ¿Quieres hacerle una pregunta a nuestra comunidad y sus expertos?
Regístrate gratis
Ad